What is the best type of 6mm screw ito use with bitmac Tarmac to hold metal profiles.any help appreciated

Views: 81

Reply to This

Replies to This Discussion

what is under the tarmac? if its just scalpings then 20mm base tarmac and then top coat tarmac then i would say there is not much you could use that will stay there for very long unless you drove some angle iron in at the edge of the tarmac and screwed the profiles to them

Reply to Discussion

RSS

© 2013   Landscape Juice ® Limited - Registered in England 08356644

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service